If you have air flowing only through the vents with no defrost or floor this door is failing.
2005 dakota no floor heat.
Tough to drive because the windshield is frozen.
I have a 2000 dodge dakota that when i press on the accelerator the blower for ac and heat will transfer to floor board.
Dodge ram 02 08 the heatertreater replaces any of the plastic doors in the dodge ram hvac system with steel.
Just recently we had quite a cold snap much below zero.
The rest of the heat works except the floor vents.
I ve removed the heat blend door actuator thinking it is the probem.
I experienced no heat in my wife s 1999 dodge dakota.
When the heater or defroster is turned on warm engine coolant passes through the heater core.
I used a socket attached to a socket swivel to replace mine in under 10 minutes.
Hello i have a 2004 hemi 5 7 4x4 ram.
It is located to on the firewall behind the glove box on the lower left side of the blower assembly.
Getting cold outside please help.
The purpose of a heater control valve is to control the flow of engine coolant to the heater core located within the passenger compartment.
Two 5 5mm screws hold it in place 1 4 inch socket works too.
The failure is a result of excessive forces generated by.
Now the heater will not go to the floor or the defroster just blasts through the center vents.
The two doors that governs flow between dash vents and defrost floor are mode door 1 and mode door 2 mode door 1.
Dodge dakota s heater not working.
On the floor it s cold toes.
What i did was reverse flush the heater core.
2005 dodge dakota blend door assembly.
My 2002 dodge dakota has no cabin heat ive got heat my 2002 dodge dakota has no cabin heat i ve got heat to the core so i suspect that there is an issue with the blend door.
This door regulates air flow to either the dash vents or defrost floor.
Make sure you have plenty of coolant or antifreeze.
Replacing the existing doors with another plastic door is at best a stop gap solution.
Heater now works as good as new.
Dodge dakota s heater not working.
Here a fan forces air across the surface of the heater core and then into the passenger compartment where the warm air is felt.