2008 Chevy Impala Key Fob Programming

Insert the original already programmed key in the ignition and start the engine.

2008 chevy impala key fob programming.

Press and hold the lock and unlock buttons on the keyless remote at the same time for approximatley 15 seconds. Remove the existing key and within 5 seconds insert new key and turn it to the on position for 5 seconds. Keyless entry fob remote programming for all vehicles. Free keyless fob procedures for your new or used replacement fob.

The chevrolet impala has been manufactured throughout the 1990s and 2000s and today offers drivers the keyless entry remote system. 2011 up vehicles require dealer or locksmith programming only. To program additional remotes at this time repeat step 4. This vehicle can have a maximum of eight remotes programmed.

Whether the system was installed with the car or purchased as an aftermarket option you can program or reprogram your remote in just minutes from the car. Remove the existing key and within 5 seconds insert new key and turn it to the on position for 5 seconds. 2008 chevrolet impala remote programming there are 2 possible procedures for this gm vehicle note. 2008 chevrolet impala we strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on northcoast keyless.

Chevrolet automotive remote programming instructions. Turn key off then back to on. A chime will sound indicating that the remote is programmed. Start vehicle to test key.

Press the set reset button until remote key learning active displays press and hold the lock and unlock buttons on the keyless remote at the same time for approximatley 15 seconds. A chime will sound indicating that the remote is programmed. The instructions will not work for 2011 up vehicles. Turn ignition to the on position for 5 seconds then back to off position.

Insert an existing programmed working key into the ignition cylinder. To program additional remotes at this time repeat step 4. Turn ignition to the on position for 5 seconds then back to off position. Insert an existing programmed working key into the ignition cylinder.