2010 Ford Focus Tire Pressure Sensor Fault Reset

Being that i live in florida the air is 95 degrees and humid.

2010 ford focus tire pressure sensor fault reset.

If the light continues to come on check for a tyre leak or possible fault with a tpms in one of the tyres. Turn key off when engine restarts the tire pressure light is off. Locating the tire pressure sensor. Place the tpms reset tool on the left front tire wall near the air stem and activate it until the horn sounds.

Each tire has a sensor. Check your owner s manual for the location of the tpms tire pressure monitoring system reset button. Sometimes the sensor system simply needs resetting. When changing any of your tires take care to avoid damaging the sensor.

Place the tpms reset tool on the right front tire wall near the air stem and activate it until the horn sounds. After 17 miles dash light comes on and says tire pressure fault. Undercarriage is clean tires are clean. This video might be helpful.

Tire pressure sensors have been replaced. Place the tpms reset tool on the right back front tire wall near the air stem and activate it until the horn sounds. Put the key in the ignition and turn it to the on position but do not start the car. Since the sensor is attached to the valve stem it is covered by the tire and not visible unless the tire is removed.

Each road tire is equipped with a tire pressure sensor which is located inside the wheel and tire assembly cavity. For further help regarding the tpms see tyre pressure light keeps coming on. The tyre pressure monitoring system will now have been reset on the ford focus and the warning light should go out. Use your vehicle s tpms reset button.

Stored in a garage. Tire pressure sensor fault 6 answers. Will come back on randomly after 17 miles. Have taken the vehicle and tire pressure sensors test good.