2011 Ford Fusion Blend Door Actuator Problems

Having hvac problems on my 2010 fusion.

2011 ford fusion blend door actuator problems.

Your order may be eligible for ship to home and shipping is free on all online orders of 35 00. Had no ac this morning all worked 100 last night no problems. Order blend door actuator for your 2011 ford fusion and pick it up in store make your purchase find a store near you and get directions. 2012 fusion blend door.

I have replaced the blend door and sensor in dash. Best advice for diagnosing and fixing a ford heater blend door actuator problem. Equip cars trucks suvs with 2011 ford fusion a c heater blend door actuator from autozone. Temp switch cranked full cold or full hot position i get full hot blowing out vents.

Ford climate control relies on a series of ducts and a blower motor as well as a blend door assembly and blend door actuator to properly route the warm or cold air from the ac or heater into the cabin. A problem with the blend door actuator motor in which case you must replace the actuator or a problem with a binding or stuck blend door. Going to get a used one and see if that solves the erratic hot and cold issues. First the electric motor can burn out rendering the unit non responsive so nothing changes when the temperature or.

Remove the blend door actuator and try opening and closing. We have the best products at the right price. I ve been doing some research and it seems like a lot of people have this issue with this particular car. An actuator can go bad in of two ways.

The blower motor and blend door actuators are both mechanical devices and as with all such components prone to failure. I have a 2011 ford fusion with a little over 130 000 miles. Ac works hot pipe is hot cold pipe is cold. Check here for special coupons and promotions.

120 later i still have the same issue. A blend door actuator is made up of an electric motor that turns a plastic gear set in one direction or another which is connected to an air control door pivot at the final drive of the unit. The mechanic told me that it looked like my actuator blend door was sticking so i had him order the part and replace it.