The actuator that changes temperature is good the actuator that doesn t is bad.
2014 ford edge blend door actuator drivers side.
When ac is turned on hot air is blowing from driver side vents and cold air from passenger vents.
I did two things that could have fixed it.
Fix actuator causing blows cold one side hot on other side condition.
The driver side heat on my 2014 ford edge was not working.
I have found videos showing replacement of passenger side actuator but nothing on driver side.
If your electrical parts are in need of repair don t compromise the performance and safety of your car with suspect off brand.
This test also proves out the hvac controller.
Ford edge blend door actuator location and replacement explained if you where the blend door actuator is located and we will explain what needs to be done to.
I went ahead and unplugged the hvac actuator while the car was running and plugged it back in presto problem solved.
Look up see 2 screws remove them and the panel they hold on.
Blend door ok first put you front seat down and back raise steering wheel.
Driver side blend door actuator replacement.
Both temp are set at 69 degrees.
I assuming driver side is more.
The first was to hold the defrost and control power b.
The actuator on the driver s side is located down below the dash above the brake and accelerator pedals.
Ford edge with keyless entry system 2014 front driver side door lock actuator motor by genuine.
Now lay on you back with you head in the drivers floor board.
Look to left main wire harness needs to be moved to the right up and behind it is th blend actuator 7 32 socket to remove it then manually turn the white peg total labor 30 min.
I have a 2014 ford edge with dual climate controls.
The blend door actuators are located right on the heater box behind the dash.
My wife s 2013 ford edge sport was blowing hot air on driver s side and cold air on passenger side.
What could possibly causing thi.
If the door mechanically moves as it should but the actuator won t replace the rh temperature blend door actuator.
Hi james replacement of the blend door actuator is not needed.